CMS 134 Diabetes: Medical Attention for Nephropathy

Greenway Health's Regulatory Resource Hub provides a single-access point for information about regulatory reporting.

Click the following dropdown to see what's new for this measure in 2020.

Overview

This measure reports the percentage of patients with either type 1 or type 2 diabetes who had a nephropathy screening test or evidence of nephropathy. Only patients who were 18-75 years old are counted.

eMeasure ID	CMS134v8
NQF	Not Applicable
Used For?	Medicaid PI/Stage 3, MIPS (Quality)
Domain	Effective Clinical Care
MIPS Quality ID	119
MIPS Measure Type	Process
MIPS High Priority?	No

Measure Specification and Value Sets

You should be familiar with this measure’s specification, Value Sets, and direct reference codes (if applicable). Refer to Downloading Measure Specifications and Value Sets for more information. Measure help now includes hyperlinks to the Value Sets used by this measure. You must be registered for a UMLS license and signed in to your account to see this content.

Identifying Event Times

See Identifying Event Times for important information about the logic this dashboard uses.

Amending Signed Notes

As a best practice, Notes should not be signed until they are finalized. Amending a signed Note (by making changes to it in Prime Suite and then re-saving it) will change a patient’s qualification for this measure. Re-signing the amended Note may allow the patient to qualify again, but only if it is re-signed during the time period required by the measure.

Documenting Recorded Medications in Prime Mobile

If using Prime Mobile to document a recorded medication, you must enter a non-zero duration. Entering a duration ensures the medication's end date calculates properly and that the medication can qualify for eCQMs. Otherwise, Prime Mobile defaults the medication's end date to midnight of the date recorded. Since this can cause the medication’s end date and time to occur before its start date and time, the medication would not count towards any eCQMs looking for active medications.

Measure Calculations

Initial Population	Patients 18-75 years of age with diabetes with a visit during the measurement period.
Denominator	Initial Patient Population
Numerator	Patients with a screening for nephropathy or evidence of nephropathy during the measurement period.

Measure Details

Initial Population/Denominator

Patients are counted in the denominator if they meet each of the following:

They were 18-74 years old at the beginning of the measurement period. Patients who turn 75 during the measurement period will qualify. Patients who turn 76 during the measurement period will not qualify. Age is based on the date of birth (DOB) entered on the Information page.

They had at least one non-voided face-to-face encounter during the measurement period. This must be documented in the Plan or E&M section of a Note using a code from one of the following Value Sets:

They had a diagnosis of diabetes that overlapped the measurement period. This means that one of the following will be true: either its start date or end date occurred during the measurement period, both its start date and end date occurred during the measurement period, or its start date occurred before the beginning of the measurement period and its end date occurred after the end of the measurement period or it was never ended. This diagnosis must be documented using a code from the Diabetes Value Set. This can be indicated by either of the following:

An active diagnosis documented in Past Medical History (PMHx) on the Facesheet. The diagnosis must be documented with a valid onset date. Note that if the diagnosis is entered in Past Medical History (PMHx), the diagnosis will remain in the patient's history indefinitely. The only way to end the diagnosis is to add it through the Problem List and enter a resolved date.
An active, resolved, or inactive diagnosis on the Problem List. The diagnosis must be documented with a valid onset date. If resolved, the diagnosis must also have a valid resolved date.

When documenting in Past Medical History (PMHx) or the Problem List, a Date of Onset should be entered using the mm/dd/yyyyy format. For PMHx, use Code Mapper to ensure that the term you’re using has been mapped to a code from the correct Value Set (Chart > Vocab Admin > Code Mapper > PMHx).

Denominator Exclusions

Patients will be excluded from the denominator if they meet any of the following. Select a link for additional information.

They received hospice care during the measurement period.
They were in long term care.
They had an advanced illness and frailty.

When documenting in Past Medical History (PMHx) or Past Surgical History (PSHx), a Date of Onset should be entered using the mm/dd/yyyyy format. For PMHx and PSHx, use Code Mapper to ensure that the term you’re using has been mapped to a code from the correct Value Set (Chart > Vocab Admin > Code Mapper > select section).

Hospice Care

Patients who received hospice care will be excluded from the denominator. This can be indicated by any of the following:

They were discharged from the hospital into hospice care during the measurement period. This must be documented with a vocabulary term using a parent code from the Encounter Inpatient Value Set and a child code using either of the following SNOMEDCT version 2019-05-10 direct reference codes:
- 428371000124100 indicating a patient was Discharged to a health care facility for hospice care.
- 428361000124107 indicating a patient was Discharged to home for hospice care.
They received hospice care. This must be documented with a vocabulary term in a Flowsheet using a code from the Hospice care ambulatory Value Set. The date the provider enters this documentation must occur during the measurement period.
They had an order for hospice care. This must be documented in the Plan or Results section of a Note using a code from the Hospice care ambulatory Value Set. This order must have been created during the measurement period.

Long Term Care

Patients who spent more than 90 days cumulatively in long term care during the measurement period will be excluded from the denominator. They must meet each of the following:

They were 65 years old or older at the beginning of the measurement period, based on the date of birth (DOB) entered on the Information page.

They spent more than 90 cumulative days in a long-term care facility during the measurement period, documented with an encounter. This encounter can be documented in a clinical note linked to a single day visit for each day the patient was in the long-term care facility or a clinical note linked to a multi-day visit. A single day visit must have a duration of 24 hours or greater to qualify. This means that the visit's end date must not occur less than 24 hours after the visit's start date. The encounter must be documented using codes from either of the following Value Sets:

Advanced Illness and Frailty

Patients with advanced illness and frailty during the measurement period will be excluded from the denominator. This must be indicated by each of the following:

They were 65 years old or older at the beginning of the measurement period, based on the date of birth (DOB) entered on the Information page.

They had a device, diagnosis, or symptoms of frailty. This must be indicated by any of the following:

An order for a device related to frailty created during the measurement period, documented in the Plan section of a Note, using codes from the Frailty Device Value Set.
A device related to frailty was applied that overlapped the measurement period. This device must be documented in the Frailty widget, using codes from the Frailty Device Value Set.
A diagnosis of frailty that overlapped the measurement period. This diagnosis must be documented using a code from the Frailty Diagnosis Value Set. This can be indicated by either of the following:
- An active diagnosis documented in Past Medical History (PMHx) on the Facesheet. The diagnosis must be documented with a valid onset date. Note that if the diagnosis is entered in Past Medical History (PMHx), the diagnosis will remain in the patient’s history indefinitely. The only way to end the diagnosis is to add it through the Problem List and enter a resolved date or inactivate it.
- An active, resolved, or inactive diagnosis on the Problem List. The diagnosis must be documented with a valid onset date. If resolved, the diagnosis must also have a valid resolved date.
A frailty encounter that overlapped the measurement period, documented in the Plan or E&M section of a Note, using a code from the Frailty Encounter Value Set.
A symptom of frailty that overlapped the measurement period, documented in the Frailty widget, using codes from the Frailty Symptom Value Set. They symptom must be documented with a valid onset date. If resolved, the symptom must also have a valid resolved date.

To overlap the measurement period, one of the following must be true: either its start date and time or end date and time occurred during the measurement period, both its start date and time and end date and time occurred during the measurement period, or its start date and time occurred before the beginning of the measurement period and its end date and time occurred after the end of the measurement period.

They meet one of the following:

They had two outpatient encounters for advanced illness. These encounters must meet each of the following:

Each encounter must begin two years or less before the end of the measurement period.

Each encounter must be documented in the Plan or E&M section of a Note, using a code from one of the following Value Sets:

Each encounter must include a diagnosis of advanced illness documented using a code from the Advanced Illness Value Set.

They had one inpatient encounter for advanced illness. This encounter must meet each of the following:

The encounter began two years or less before the end of the measurement period.

This encounter must be documented in the Plan or E&M section of a Note, using a code from the Acute Inpatient Value Set.

The encounter must include a diagnosis of advanced illness documented using a code from the Advanced Illness Value Set.

They had a prescription for a dementia medication that overlapped the measurement period or the year prior to the measurement period. This means that one of the following must be true: either its start date and time or end date and time occurred during the measurement period or the year prior to the measurement period, both its start date and time and end date and time occurred during the measurement period or the year prior to the measurement period, or its start date and time occurred before the beginning of the year prior to the measurement period and its end date and time occurred after the end of the measurement period. This can be documented in the Medication List as either a prescribed medication or recorded medication, using codes from the Dementia Medications Value Set.

Numerator

Patients are counted in the numerator if they had a nephropathy screening test or evidence of nephropathy. This can be indicated by certain encounter findings, lab results, or patient problems. To be counted in the numerator for this measure, a patient must meet at least one of the following:

They were on angiotensin-converting enzyme inhibitors (ACE inhibitors) or angiotensin receptor blockers (ARBs) that overlaps the measurement period. This is indicated by a prescription that overlaps the measurement period. This means that one of the following will be true: either its beginning or ending occurred during the measurement period, both its beginning and ending occurred during the measurement period, or its beginning occurred before the beginning of the measurement period and its ending occurred after the end of the measurement period. This must be documented in the Plan section of a Note or on the Medication List using a code from the ACE Inhibitor or ARB Value Set.

If using Prime Mobile to document a recorded medication, you must enter a non-zero duration for the medication to qualify. See Documenting Recorded Medications above for more information.

They had a diagnosis for a disease or condition represented by a code from one of the following Value Sets. This must be documented in the Problem List (with an Active status) and must overlap the measurement period. This means that one of the following will be true: either its beginning or ending occurred during the measurement period, both its beginning and ending occurred during the measurement period, or its beginning occurred before the beginning of the measurement period and its ending occurred after the end of the measurement period.

When documenting in the Problem List, a Date of Onset must be entered using the mm/dd/yyyyy format.

They had a kidney transplant, had vascular access for dialysis prepared, or received dialysis services during the measurement period. These can be indicated by any of the following:
- An order, documented using a code from one of the following Value Sets: Kidney Transplant, Vascular Access for Dialysis, or Dialysis Services. In Orders Tracking History, this order must have a status of Returned or Reviewed.
- A result value documented using a code from one of the following Value Sets: Kidney Transplant, Vascular Access for Dialysis, or Dialysis Services. This must be documented with a vocabulary term in the Results or in a Flowsheet.
They received other services related to dialysis or dialysis education during the measurement period. This must be documented with a vocabulary term in the Results or in a Flowsheet using a code from one of the following Value Sets: Other Services Related to Dialysis or Dialysis Education.
They received monthly outpatient services related to end-stage renal disease (ESRD) during the measurement period. This must be documented as an order, using a code from the ESRD Monthly Outpatient Services Value Set. In Orders Tracking History, this order must have a status of Returned or Reviewed. This can also be documented in the E & M section of a Note.
They had a resulted urine protein test during the measurement period. This must be documented with a vocabulary term in the Results or in a Flowsheet using a code from the Urine Protein Tests Value Set. The vocabulary term must include the unit of measurement.

Numerator Exclusions

Not Applicable

Denominator Exception

None